Characteristics: | Single component basecoat with metallic, especially silver and pearl effect, made from weathering resistant resins, high quality, strong coverage power, and excellent adhesion power. |
Surface cleaning: | Sand and clean the substrate (old paint film or 1K, 2K primer) with EC-5910 Degreaser With sanding paper P600-P800 for wet sanding, and P400-P600 dry sanding. |
Mixing ratio: | Metallic Basecoat: Reducer = 1: 0.6-0.8 Mix with EC-5520 1K Binder or EC-5530Flip Controller to speed up air drying time, enhance the orientation ofmetallic particles, and improve property in application. Add EC-5960 Retarder Solvent when temperature is over 30℃ (54℉). |
Spray Gun | Gravity feed: 1.2-1.4mm; HVLP: 2.0 bar |
Spraying | Spray 2-3 coats, total should be 15-25μm 5-10flash-off time at 20℃ between coats. After spray, 10 -15 minutes’ air dryingbefore spraying clear coat. |
Defects preventing | Professional mix and spray techniques can prevent defects of poor metallic effect s and mottling. Spray too thick or air drying too long might cause poor adhesion. |
Contact
Supplier