Parameters
Charge Input Voltage :AC 100-240V,50/60Hz
Charger Socket :DC5V
Battery :3500mAH
Wavelength :400nm - 490nm
Light Density :≥2700mw/ cm².
Operation Instruction
A. Charge
Put the curing light into the charger socket, the yellow
light is on.
When it is done, the green light is on. It takes about 4-6
hours.
Remove the adapter from the power supply after charging.
B. Operation Details
Press the ON/OFF button,it is on.
Press the ON/OFF button over 3 seconds, it is off.
When it is on, you can set the TIME(from 1 - 6
seconds) ,then press the ON/OFF button, it is working;
press the ON/OFF button again, it stops.
It will turn off automatically without any operation in a few
minutes.
If it buzzs 5 times,it must be charged before using.
Contact
Supplier