2 Component Solvent ink

Feature:

1.This double components ink add hardener additional. Excellent adhesion after heat dry, even have strong ahesion on some coated hard adhere.

2.The mixture is wear-resistance, alcohol resistance and solvent resistance. especial widely for the glass accessories as well.

How to use:

1. After Mix with hardener, mixing the thinner/diluent 8% to 10% with spatulas spoon. Must mixing slowly, until the ink look flow.

2. Lied the ink on the stencil/screen plate, apply the squeegee 75A printing on with 200 mesh to 300 mesh. and check the printed ink whether smooth.

3. Drying the printed ink 4 hours by room temperature. For better adhesive, still there more 24H to 48H having good adhesive.

4. It need to put on the drying rack and a no-dust room.

Note:

1. Apply the ink Spatulas Spoon mixing hardener 5% to 10% with ink, and mixing slowly, do not mix air into the ink.

2. (If there have much bubble, still there for a while until the bubble are disappear.)

3. The ink with hardener must use up in 8 hours. If could not finish, need to re-mixed hardener with same rate.

4. Do not mix new ink with used one.

5. Do not wing dry when the temperature below 18°C because of the failure crosslinking reaction of ink, then affect the ink performance.