The principle process of water passage of the machine:
The pressure of raw water must be greater than 0.2Kg/cm2 because of a spare part in the
pure water machine. If the pressure is lower than this, the pure water machine will not start
the water. The raw water enters the pure water machine through the inlet three ways. There
is a 2 points (3 points) on the inlet tee small ball valve - inlet ball valve, its main role is: in the
water water machine water leakage or pure water machine waste water flow does not stop
under the situation cut off the raw water source of pure water machine, waiting for professional
technical personnel to deal with.
Through the inlet ball valve after you came to the first level of pure water machine filter - PPF,
its diameter is 5 microns, can filter out the sediment in the water, rust, colloid, and greater than
5 micron particulate impurities, it is the main raw material for polypropylene, by high temperature
dissolving, wire drawing and winding, formed by replacement of life between 3 to 6 months,
according to the local water quality. We have just started to say why the water pressure must be
greater than 0.2 Kg/cm2 because after the water electromagnetic valve through a electrical
components, low voltage switch, it under normal circumstances is in a state of closed for a long time,
but when the raw water pressure is less than 0.2 Kg/cm2 and under the condition of water, it will
disconnect the circuit system of pure water machine disconnect, prevent the back of the idle
high-pressure pump. After the low pressure switch to the inlet solenoid valve, its internal is made
of copper wire wound, in the moment of electrification formed electromagnet will be metal plug
suction to make the water channel smooth, pure water machine power after magnetic disappear,
the metal plug will fall again to cut off the water channel.
Contact
Supplier