The full cover is also called straight bending and strai
ght arms
No matter how your door overlay are,AOSITE hinges series always can provides reasonable solutions for each application.
Model A02 also is one way hydraulic damping hinges,but the different is aluminum frame ,which we call it inseparable aluminum frame hinge.A02 can continues to provide the quality of motion you have come to expect from AOSITE. Our standars Includes hinges, mounting plates.
The full cover is also called straight bending and strai
ght arms
The cover is suitable for the cabinet body which cover
s the side panels.
The cupboard door covers the side plate, half of which has doors on both sides of the cabinet.
The door is not covered by the cabinet door, and the cabinet door is inside the cabinet.
Full Overlay
This is the most common construction technique for cabinet doors.
You will be able to identify if your hinge is Full Overlay:
The Hinge Arm is relatively straight with no "hump" or "crank"
The Cabinet Door overlaps close to 100% on the cabinet side panel
The Cabinet Door does not share a side panel with any other cabinet door
H=15+K-D
Half Overlay
Much less common but used where space saving or material cost concerns are most important.
This technique uses the same side panel for two cabinets. To achieve this
you would need a hinge that provides these features:
The Hinge Arm starts to bend inwards with a "crank" that offsets the door
The Cabinet Door only overlaps a bit less than 50% of the cabinet side panel
The Cabinet Door does not share a side panel with any other cabinet door
H=5+K-D
Inset/Embed
This is a technique of cabinet door production that allows the door to sit
inside the cabinet box.
You will be able to identify that your hinges are Inset if:
The Hinge Arm is quite noticeably bent inwards or highly "cranked"
The Cabinet Door does not overlap with the side panel but sits inside
H=A+K-4
H=Height of mounting plate
D=Required overlay on the side pane
K=Distance between door edge and dritlling holes on
hinge cup
A=Gap between door and side panel
X=Gap between mounting plate and side panel
Refer to the following formula to choose the arm of hinge,if you want to solve the problem,we must kno w “K” value ,that’s the distance drilling holes on the door and “H”value which is the height of mou nting plate.
asNO | 1 | 2 |
Hole Type | Two holes | Four holes |
H Value | H=0/2 | H=0/2 |
Mounting dimensio | 37mm | 37mm |
Type | Clip on | Clip on |
Arm cap
Single package Packing in a box
Contact
Supplier