ACL 380 100V Surface Resistance Tester Static Dissipative Specialits Staticide Control Resistivity Meter

Description:

 Note:

The battery can't be attached in transport.

  Surface Resistance Tester  ACL 380   is adopted the  astm d - 257  parallel electrode sensor method.And can test  the meterial: all kinds of transmitting, electrostatic discharge, insulating surface.

Method of  Measuring the surface impedance  : To measure the surface impedance of the table, Put the tester in to be measured on the surface, hold down the red measurement (test) button, continuous bright light-emitting diodes (leds) that indicates the measurement of surface impedance magnitude

 Method of Measurement of resistance :

Put the earth wire inserted into the earth (ground) socket, so that the right side of the table detection electrode insulation (with socket on the same side).The alligator clip on the ground from you.
Put the table on the surface to be tested, hold down the measurement (test) button, continuous light-emitting led indicates the magnitude of resistance. That the unit of measurement is the ohm