Instruction
1)Open the box and check everything is included, Locate the instruction book(pic.1) .Locate the recommended pump to inflate(1 220W inside pump).
2)Open the arch, keep it laid out smooth when expanded.
3)Put the sand bags on the middle of the four trays.
4)Close the two side vent zippers
5)Attach the four ropes.
6)Find the blower of the pump in the vents.
7)Install the power supply, ensure it is safely setup to local voltage and current settings. pay close attention to electrical safety, ensuring wires are not frayed or damaged in any way, Make sure all power supply and wires do not obstruct pedestrian in order to avoid any accidents.
8)Put the plug into power source to power the pump.
9)When the arch is fully inflated with air laying flat on the ground, pull the arch up using the attached ropes and then fasten to sturdy points, ensure the ropes are taut and not twisted.
Notes:
A)Select an open area with plenty of space. pay special attention to ensure the product is not in the vicinity of the transformer (or exposed near overhead high-voltage cables).
B)Do not use the arch in rain or windy weather conditions .lf encounter heavy rain, ensure to cut off the power supply and remove the air pump. After the rain has stopped and inflatable arches are dry with no moisture, the pump can be re-attached,reconnected to power supply and used again in dry conditions.
C) Working conditions: Temperature 50 degrees C, humidity 80%, wind speed below 5 of Beaufort Scale.
Packing
Accessory
inside blower
outside Blower
Contact
Supplier
