Flame-retardant silica gel is used for the power supply's subsequent filling and sealing, electronic and electrical components are fixed and flame-retardant, insulated and sealed waterproof, environmentally friendly, non-corrosive materials.
Electrical circuit board
Power Adapter
Electrical components
CPU bonding
Semiconductor material bonding
Electronic circuit board
| Type | SD9088W |
| Name | Test value |
| Color | white/black paste |
| Density(g/cm3) | 1.3～1.35 |
Tack-free time（25℃,min） | 3～10 |
| Tensile strength（MPa） | ≥2.0 |
| Elongation（%） | 200～300 |
| Shear strength（MPa） | ≥2.0 |
| Hardness(shore A) | 50～60 |
| Temperature range（℃） | -50～250 |
| Permittivity（@60Hz） | 2.9 |
| Dielectric intesity（kV/mm） | ≥20 |
| Volume Resistance（Ω.cm） | 0152.0×1 |
| Flammable | V-0 |
The surface of the substrate must be degreased and dried, and corona treatment can improve the bonding effect.
The silicone adhesive sealant has a surface cure time of about 20 minutes and is fully cured after 24 hours.
1. Keep thermal paste out of reach of children.
2. Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer. This product has not been tested for, and is therefore not recommended for, uses for which prolonged contact with mucous membranes, abraded skin, or blood is intended; or for uses which implantation within the human body is intended.
Contact
Supplier
