The principle process of water passage of the machine:
The pressure of raw water must be greater than 0.2Kg/cm2 because of a spare part in
the pure water machine. If the pressure is lower than this, the pure water machine will
not start the water. The raw water enters the pure water machine through the inlet three
ways. There is a 2 points (3 points) on the inlet tee small ball valve - inlet ball valve, its
main role is: in the water water machine water leakage or pure water machine waste
water flow does not stop under the situation cut off the raw water source of pure water
machine, waiting for professional technical personnel to deal with.
Through the inlet ball valve after you came to the first level of pure water machine filter -
PPF, its diameter is 5 microns, can filter out the sediment in the water, rust, colloid, and
greater than 5 micron particulate impurities, it is the main raw material for polypropylene,
by high temperature dissolving, wire drawing and winding, formed by replacement of life
between 3 to 6 months, according to the local water quality. We have just started to say
why the water pressure must be greater than 0.2 Kg/cm2 because after the water
electromagnetic valve through a electrical components, low voltage switch, it under normal
circumstances is in a state of closed for a long time, but when the raw water pressure is
less than 0.2 Kg/cm2 and under the condition of water, it will disconnect the circuit system
of pure water machine disconnect, prevent the back of the idle high-pressure pump. After
the low pressure switch to the inlet solenoid valve, its internal is made of copper wire wound,
in the moment of electrification formed electromagnet will be metal plug suction to make
the water channel smooth, pure water machine power after magnetic disappear, the metal
plug will fall again to cut off the water channel.
Contact
Supplier