Protective non-toxic anti-Collision Acrylic Handy Aerosol Auto Chassis Armor Spray paint

a.Lasting adhesion and impact resistance, long-term rust protection for metal.
b.Excellent elasticity, reduce the impact damage of pavement gravel on the car, and greatly reduce the distance between the tire and the road surface. Walking noise spreads and enhances the sense of tranquility and comfort in the car.
c.Short drying time, good flexibility, strong adhesion, antistatic effect.
e.Water resistance and corrosion resistance, but also has strong impact resistance.

a.Cars: anti-rust collision-resistance, water-proof, and sound insulation performance, used in all kind of automobile chassis, fender trim, bumper, vehicle hood, automotive frame, tank shell, truck.
b.Architect and building: building-waterproof, plugging roof and toilet, basin, and water pipe cracks. Air conditioner installation and repair. Waterproof and noise insulation application for building foundation, etc.

a.Product-state inside the contain: no foreign bodies, lumps, a viscous homogeneous liquid which is easy to in be blunt.
b.Water-resistance: does not blanch, no bubble, or shedding with long   time-soaking.
c.Drying time: 30 minutes for the surface, 24 hours for full drying.
d.Flexibility(MM): less than 3.
e.Adhesion capacity: an even concave-convex feeling.
f.Resistance to impact: positive impact of 50 kg/CM.
g.Salt spray resistance: 120 hours under 45 Celsius degree.

a.The vehicle spraying part should be thoroughly cleaned to achieve no rust, no water, no dust, no oil, no wax traces, clean afterwards, dry thoroughly with the wind.
b.Cover areas that do not need to be covered with waste newspapers (including exhaust pipe, body, engine, water tank, spring, air conditioner, condenser, frame number, etc.).
c.Open the bottle cap, insert the special airbrush for the factory and shake the product for about 2 minutes so that the contents of the tank can be mixed evenly. Followed by 0.60-0.80 Mpa of compressed air, then sprayed evenly about 25-50cm from the sprayed surface.
d.It is recommended to spray three time to prevent flow marks and sagging, not to spray too thick, there must be between each spraying foe a certain time interval, it is better to be about 15 minutes apart at normal temperature. After the first spraying is finished, there are holes oil, cracks, and joints must be sprayed. The thickness is more than 2mm and the soundproof and rust prevention effects are obvious.
e.After drying, seal, install and complete the construction.

a.This product contains organic solvents, please use it in an open space.
b.When using, operator should wear protective mask or protective glasses and gloves.
c.This product is a high pressure product, do not pierce the tank.
d.A large amount of inhaled gas or swallowed solids may cause irritation to the body.
e.If strayed into eye or get in contact to skin, please wash with a plenty amount of water and soap,if the condition is serious; please see a doctor immediately.
f.Keep away from children, heat, sunlight, and or high temperature storage.To prevent spontaneous combustion;please use in environment less than 40℃.