The solar component sealant is used for sealing the solar cell module frame, bonding the solar cell module junction box, and sealing the solar lamp. The solar sealant has excellent UV resistance, yellowing resistance, excellent weathering resistance, rain, anti-fouling and hail impact resistance, and good adhesion to aluminum, glass, junction box plastic and other materials.
Type | SD9099 |
Color | White paste |
Density(g/cm3) | 1.35~1.40 |
Surface dry(25℃,min) | ≤12 |
Tensile strength (MPa) | ≥2.0 |
Elongation(%) | 200~300 |
Shear strength(MPa) | ≥2.0 |
Hardness(shore A) | 50~55 |
Temperature range(℃) | -50~250 |
Permittivity(@60Hz) | 2.8 |
Dielectric intesity(kV/mm) | ≥18 |
Volume Resistance(Ω.cm) | 1×1015 |
Flammable | UL 94-V0 |
The surface of the substrate must be degreased and dried, and corona treatment can improve the bonding effect. The silicone adhesive sealant has a surface cure time of about 20 minutes and is fully cured after 24 hours.
1. Keep thermal paste out of reach of children.
2. Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer. This product has not been tested for, and is therefore not recommended for, uses for which prolonged contact with mucous membranes, abraded skin, or blood is intended; or for uses which implantation within the human body is intended.
Contact
Supplier