45mm Cup
Diameter of the hinge cup or "boss" that inserts into the cabinet door is 35mm.
Distance between screw holes (or dowels) is 45mm.
Center of screws (dowels) is 9.5mm offset from the hinge cup center.
No matter how your door overlay are,AOSITE hinges series always can provides reasonable solutions for each application.
Automatic buffer closing and 15 degree small angle buffer that’s AOSITE two ways hydraulic damping hinges’ features .Hydraulic damping hinges have the soft close mechanism integrated in the hinge cup, and continues to provide the quality of motion you have come to expect from AOSITE. Our standars Includes hinges, mounting plates,.Screws and decorative cover caps are sold separately.
D:Overlay calculation form
A:Gap calculation form
H=Height of mounting plate
D=Required overlay on the side pane
K=Distance between door edge and dritlling holes on hinge cup
A=Gap between door and side panel
X=Gap between mounting plate and side panel
Refer to the following formula to choose the arm of hinge,if you want to solve the problem,we must know “K” value ,that’s the distance drilling holes on the door and “H”value which is the height of mounting plate.
Step 1: According to the installation data, drilling at the proper position of the door panel.
Step 2:Install the hinge cup
Step 3:According to the installation data,mounting base to connect the cabinet door.
Step 4:Adjust back screw to adapt door gap.
Step 5:Check opening and closing.
Contact
Supplier