PC 2K Solid Colors | |||||
Characteristic: Medium and high class 2K topcoat solid colors, good hardness, high gloss and build, excellent protective and coverage power, long lasting bright color. Substrates: Sanded and dried existing finishes, 1K or 2K primer. | |||||
Surface Cleaning: | Remove wax, silicon and other contaminations with degreaser | ||||
Solid Colors | Hardener | Thinner | |||
Mixing Ratio | 2 | 1 | 0.2-0.5 | ||
<18°C | 2K Solid Colors | PC-6611 | PC-1 | ||
18°C - 24°C | PC-6612 | PC-1/PC-2 | |||
25°C - 30°C | PC-6612 | PC-2/PC-3 | |||
>30°C | PC-6613 | PC-3 | |||
Pot-life at 20°C | 2 hours with PC-6611 fast hardener | ||||
4 hours with PC-6612 standard or PC-6613 slow hardener | |||||
Spray Gun Set-up | Gravity Feed: 1.2-1.4mm Suction Feed: 1.3-1.5mm | ||||
Conventional: 3-4 bar RP: 2.0-2.5 bar HVLP: 2.0 bar | |||||
Coats & Thickness | 2-3 coats, total 40-60 um | ||||
Flash-off Time | At 20°C, 5-10 minutes between coats | ||||
Air-drying Time | Allow 15-20 minutes air drying time before force drying | ||||
Drying Time | |||||
Temperature | Dust Free | Tack Free | Dry to Handle | Dry to Polish | |
20°C | 45 minutes | 2-3 hours | 10 hours | 16 hours | |
60°C | 5 minutes | 15 minutes | 30 minutes | 60 minutes | |
Note | |||||
1. The substrate must be sanded and cleaned before spray. (wet sanding: P600-P800, drying sanding: P400-P600) | |||||
2. At temperature lower than 15°C, air-dry at ambient temperature is not recommended. Allow a full bake at 60°C. | |||||
3. At ambient temperature higher than 30°C, add Retarder Solvent into thinner to avoid blushing. For details please refer to the TDS of Retarder Solvent. | |||||
4. In the event of fisheyes during application, add 0.5-1% Anti Silicon in the paint remained and re-spray the affected area. | |||||
5. In the overspray area of new and existing finish, apply directly Thinner SRA to achieve an invisible transition. For details please refer to the TDS of Thinner SRA. | |||||
6. The products mixed with hardener should be used up soon and can not restore for future use. | |||||
7. Clean equipments immediately with solvent after application. | |||||
8. If there are particles or runs after spray, sand the affected area with P1200-P2000 sand paper after thorough drying, then polish to solve the problem. | |||||
Shelf Life: 2 years in original sealed can at cool and dry place at 20°C | |||||
Packaging: 1L or 3.75L |
Contact
Supplier